Bent and Dent

On the back of the coil, 17" from bottom, there is a small ding and on the front of the coil there is a light scratch approximately 5" long.

A little out of square. On the top back left corner there is a 2" long crease.

Coil has bottom damage, not visible, with a light scratch on the front panel.

Very tiny ding 8" from rear, along top edge on left hand side.

Small ding, 17" from bottom on back panel, also, 5" scratch on front panel, 20" from bottom.

Bottom left corner lightly scratched.

Bottom, underside, dented due to being set down to hard, no visible damage to any side.

Very slight indentation on bottom right edge.

Left top corner 1" crease, scratched in bottom center of front panel, back panel scratch marks.

Left side at top from front to back dented in about 1". Small scratch marks on left panel. Back panel scratches with small dent in center at top.

Previously installed. Minor scratches.

Small dent on top left panel.

Misapplied. Customer installed before noticing it was a 2ton coil and not a 3ton coil.